Haibike AllMtn 6 Tubeless conversion

[DDenis]

I have tried to convert the rims of my Haibike AllMtn 6 in tubeless but faced some difficulties.
I have used a Shwalbe tape (29 mm wide) and the valves here after (Quaxar Tubeless Valve Universal acheter | Bike-Discount).
I failed to make the system tight around the valve. I think this comes from the rim's fairly deep profile.
interrested by your recommandations
Thank You

 

[Jackware]

On some rims I've used a 2cm square of inner tube rubber with a hole smaller than the valve stem made in it, that I've then pushed the valve through to make a sealing washer between the valve and rim. Also really push down hard on the valve base when tightening the threaded nut and keep trying to tighten a few times as the valve settles into the rubber and the rim.

 

[Sander23]

I've used 37 mm tape from dt Swiss on my 35 mm rims and valves from continental.
Was my first try on making my tires tubeless but worked like a charm