M600 bolt direction Dengfu E10

[Bafangrider]

Which way do the bolts go in for the motor? With Allen key this side (washer doesn't fit) or locknut this side?

With lock nut this side it just spins and I can't get a socket onto it. Only way is jamming a flat blade screwdriver between the nut and the carbon and that just feels wrong

 

[patdam]

i have instal the allens on this side and washers and nuts on left side. but true it is difficult to block the nut for the rear axel, I use open end wrench used almost perpendicular. If too compliquate for you, better to interface a grover washer (if enough screw thread for nylstop) between nut and whasher plate and it don't turn when you screw by allen side, With nylstop (new one if several dismantling), it isn't necessary to screw at 14NW, 6 or 8 is enough

 

[AlexRus]

[QUOTE = "Bafangrider, post: 340040, member: 18036"]
В каком направлении болты входят в двигатель? С шестигранным ключом с этой стороны (шайба не подходит) или контргайкой с этой стороны?

С контргайкой с этой стороны он просто вращается, и я не могу на него вставить гнездо. Единственный способ - зажать отвертку с плоским лезвием между гайкой и графитом, и это кажется неправильным.

View attachment 72902
[/ЦИТИРОВАТЬ]

 

[Bigchris]

I ended up getting a 13mm socket and grinding it down so that it fit in. Whoever made the tolerances on the bike must have had some midget tools