Bafang M600 Spider

[Dave Rand]

Evening chaps,
If there a non dished Spider I can get for the M600?
My Chain line is a bit crap and I would rather not use chain ring spacers to move it over as I need at least 5mm

 

[patdam]

post pics with you assembly to check if you are right

 

[Dave Rand]

Definitely needs to be 5-7mm over.
Think I’ve found one and ordered it but apparently China in lockdown

 

[patdam]

Definitely needs to be 5-7mm over.
Think I’ve found one and ordered it but apparently China in lockdown

View attachment 86889

Are you sure you will not have a problem between chain and lower swing arm pivot if you perform your modification ? it's depend of Nb of teeth of your plate, but chain pass allready very close with OEM spider. i have installed protection and it is damaged.

 

[Dave Rand]

It’s miles away from the swing arm.
I recon the 52cl Bafang spider is designed for proper 148mm boost hubs. Mine are old school Hope pro 2 hubs with 148 boost adapters which means my Cassette sits further in the wheel.

 

[patdam]

It’s miles away from the swing arm.
I recon the 52cl Bafang spider is designed for proper 148mm boost hubs. Mine are old school Hope pro 2 hubs with 148 boost adapters which means my Cassette sits further in the wheel.

OK, if you don't find it is not so difficult to change the hub (lot off time but not complicate)

 

[thaeber]

There are several chainrings with offset available (eg. Garbaruk). Did You consider this?

 

[Lucky Luke]

Esta araña tiene menos desplazamiento que la original

Page Not Found - Aliexpress.com

 

[Dave Rand]

Esta araña tiene menos desplazamiento que la original

Page Not Found - Aliexpress.com

it’s ordered but China is in lockdown again