AdrianComoSL
New Member
Will not turn on. I remove TCU and unplug Y connector. (It is completely clean and straight) reconnect and it turns on every time no problem. Shows full charge, no error lights. I can turn it on and off at will unless I leave it for a few hours…
After a few hours I try again. Will not turn on. Repeat.
Mission Control shows all firmware up to date. 3 charge cycles on battery and no problems.
Bike less than six months old has been ridden fewer than 200kms. Not been wet. Stored inside.
Please help with any ideas… bike shop have been helpful but it’s very difficult to get the bike to them. @SPECIALIZED
After a few hours I try again. Will not turn on. Repeat.
Mission Control shows all firmware up to date. 3 charge cycles on battery and no problems.
Bike less than six months old has been ridden fewer than 200kms. Not been wet. Stored inside.
Please help with any ideas… bike shop have been helpful but it’s very difficult to get the bike to them. @SPECIALIZED
