- Thread starter
- #31
Yes, only 337 from the ground to the motor axle.
I think this is the first iteration of the linkage. I got the frame around September 2025.
Cheers
Poor man's CEF69 M510 FC4.0 with 1kWh battery
- Thread starter borysgo2
- Start date
I think this is the first iteration of the linkage. I got the frame around September 2025.
Cheers
ok. thanks. like the CEF50, i will can't use it in mullet
other customer measure different value: ? 355 with 29/170/205 ?
- Thread starter
- #37
There is no 3D print for the battery.
I used 3x1 2170 cell holders formed in 3x3 factor. All sandwiched in between 3mm fiberglass,top and bottom. And for the mount I used 5x25mm aluminium bar with floating threaded inserts. Aluminium bar was offseted to make a room for brake and shift cables on the left side of the battery.
I used 3x1 2170 cell holders formed in 3x3 factor. All sandwiched in between 3mm fiberglass,top and bottom. And for the mount I used 5x25mm aluminium bar with floating threaded inserts. Aluminium bar was offseted to make a room for brake and shift cables on the left side of the battery.
Thanks
- Thread starter
- #40
Measure cells diameter, some of them have 21.5mm, make as thin spaces between cells as possible. Battery will be very tight passing through the bottom of the frame.
Why dont you just hot glue them togetther you get alot more room doing it like that, Iv built few batteries in my time, Here is one i made 6 years ago, Actually for bike in my Profile pic 20S 7P
Similar Threads
-
Poor man's CEF55 build for long trips with 1kWh battery.
- Started by borysgo2
- Replies: 8
-
-
