All
Reading through your forum with people struggling getting cables back into your tubes after dropping the motor.
Well this is what I do which makes my life easier when put the wires back in.
Push a cable from the top in the down tube so it comes out of the other end. Tape them in a tube like shape and pull the whole lot back up gently.
The cable that you pull with cut it and tuck it back into the tube.
Hope this helps
Reading through your forum with people struggling getting cables back into your tubes after dropping the motor.
Well this is what I do which makes my life easier when put the wires back in.
Push a cable from the top in the down tube so it comes out of the other end. Tape them in a tube like shape and pull the whole lot back up gently.
The cable that you pull with cut it and tuck it back into the tube.
Hope this helps