Plugged maxxis tyre

Ian222

Member
Joined
Oct 19, 2021
Messages
131
Reaction score
39
Location
England
Ok so had my first puncture today on my tubeless maxxis minion dhr. It was right in the centre and fairly big which the sealant didn’t seal so, I have plugged it and got it back up with my co2 shot. My question is, is it safe to ride from now on or should I buy a new one? Co2 has been replaced with air and it seems to be holding air.
 
⚡ EMTB Pro Go Pro — exclusive discounts & ad-free Peaty's 25% off & more · Ad-free browsing · Pro badge See the deals →
Carry on unless you like burning money, the plug will hold / last.
 
That’s good, glad you said that. Thought it might have been something that just gets you home
 
I’ve had a couple of big holes (needed to use my largest worms that are 4mm) and were a fight to fix fail a few months later after the tyre wears, , so from now on it it’s big and was a fight to fix with worms I’ll use a mushroom from the inside when I get home. Since then I’ve now got a stans dart (stated use for 5mm plus holes), but not used it in anger, , so hopefully that’ll deal with the big stuff better And May not need mushrooming.

 
Last edited:
If I get a large puncture that I don’t think the plug will hold I remove the tyre and patch it from the inside with regular superglue and a cut-out of old inner tube. I have never had one of those fail.
 
Any plug is not going to last as long as patching from the inside. I never leave a plug for long because they tend to pop out or get pulled out later on when riding.

Pick up a kit at auto parts store, follow instructions and use the included rubber cement and let dry overnight. These keep gashed tires going for months or longer.
 
I must say I didn’t fancy taking the tyre off and patching it from the inside. May see how I get on with it just plugged for now
 
It really depends how big the hole is, if it's from a thorn or is a very small hole a plug can be fine, if it's a larger cut and requires more than one plug, it's likely not going to last. Sometimes a car sized plug comes in handy, bigger than bacon strips.

One detail on patching from inside, once you've cleaned out the sealant and roughened the inside tire surface, apply the rubber cement to patch and tire and allow it to dry to the touch before pressing together, it will become much sticker, and will hold much faster. Do this with the tire turned inside out. While letting it dry, occasionally press in on patch with your fingers for the first hour or so, or find a method to clamp it between 2 pcs of wood or something heavy pressing down directly on the patch.

I will say it took me a few attempts to get right but once you have a method down it's easy. If done right will last as long as the tire.
 
It did only need 1 plug, obviously it was t enough for just the sealant to fix it
 
Keep reading
    Browse all

    Similar Threads

    Community Stats

    Since 2018
    669K
    Messages
    40,939
    Members
    Join 30,000+ Riders, it's free!
    Back
    Top