I've bought the new Purion 200 to fit to my '22 Mondraker Level R. I got this as I wanted to remove the kiox as although I quite like having the info, I'm not a fan of the out front display and this looked like the best of both worlds.
The issue I have is that the current cable from the motor isn't long enough to reach from the RHS of the frame to the purion on the bars. I looked at re routing the brake cable to the right and the smart cable to the left, but these are routed either side of the battery up the downtube, which causes the cables to kink when swapped over. So atm I'm still having to run via the kiox, which is not ideal as I've spent £170 and no better off.
Looking online there are longer cables, so if I was to buy one, is it straightforward to fit?
Like, I'm not going to have to completely disassemble the motor or something?
The issue I have is that the current cable from the motor isn't long enough to reach from the RHS of the frame to the purion on the bars. I looked at re routing the brake cable to the right and the smart cable to the left, but these are routed either side of the battery up the downtube, which causes the cables to kink when swapped over. So atm I'm still having to run via the kiox, which is not ideal as I've spent £170 and no better off.
Looking online there are longer cables, so if I was to buy one, is it straightforward to fit?
Like, I'm not going to have to completely disassemble the motor or something?