Levo Gen 2 3M/Invisiframe over the TCU?

[MrSimmo]

I think this may have been discussed but cant find the thread.

I've got a load of Invisiframe left over from fitting it to my Levo, I was thinking I could put a layer over the TCU which would seal it from the top. If the bike shop needs to take out the TCU, the Invisiframe left over is essentially free so no biggy ripping it off.

Has anyone done this or similar?

 

[malc101]

I see this is an old post, but I did that by putting at thin film of WD40 on the TCU, so that the Invisiframe would only stick to the surrounding frame.

 

[MrSimmo]

Cheers malc101