Recent content by Polo1602

Yes, the motor have to move. I found this in the Levo Megathread

You have to remove the spacer „M“ first to get the chainstay free.

So, got my new charger. They swapped my old SBC-C05 Model for die newer SBC-C07 Model. So far, so good! 🤞

Ok....will talk to my local bike shop. ;-)

Nearly the same like with -1 cap and low position. But with higher BB and the benefits of a 170 fork.

My charger is getting hot too. When it charges the last 20% (80% to 100%) my charger also makes high frequency noises. I went to my local bike shop and the shop replaced the charger. The new one makes the same noises and getting hot too. So i think it´s normal (230V - 50Hz).

If you like it slack but also wants a higher BB, travel your fork to 170 and install the neutral cup insted of the -1 with the low position. ;-)

Yes. The Spacer "M" goes thru the bearing and the frame. You must drop the motor to remove the Spacer "M". Without the Spacer "M" the chainstay is free and you can access the bearings.

No, there is no problem. I fitted the new fidlock 750ml compact bottle on my levo. It´s tight at the piggy bag but it works without issues. I also used the standard specialized screws that came with, but I had to shorten the screws because they were too long. Without shortening them they would...

Ah, ok. I had the same problem with the new hinged version, with die old type i had no issues.

Do you have the old or the new (hinged) version of the battery door?

Got the new neutral headset cup installed and everthing is fine. No play at all. When i checked the neutral headset cup which came with the bike, there were only three tiny spots where the headset cup seated/had contact in/with the seat in the headtube. I think they where wrong machined from...

That‘s not in my case. I have enough preload.

I have a alloy Levo with a minimal loose headset too. It’s loose with the neutral and the -1/+1 cup. I swapped the entire headset (bearings, spacer, crownrace , etc) but it’s still minimal loose under (heavy) load. It comes definitely from the upper cup. The upper cup is minimal slipping in the...

Maybe this helps: https://www.emtbforums.com/threads/fitting-longer-dropper-on-2022-levo.24448/#post-337727