I just tested my new Lupine SL-F with C14, got error code when I turned high beam on over 1 minute or some, with low beam there is no problem at all. Contacted Lupine last night, waiting for the reply, but it seems it was inrush current higher than 2A as SP described. Let’s see how this will...
Spot on, that’s what I feel also. Installation finished , one side arm secure screw got loose without over tightening, Lupine promised will send a free replacement
For those who curious if a rear light wiring through the seat post stop hole possible, here we are. Remove the screw, insert the cable, finish! Looks everything still keep functioning as they supposed to
you can buy a 30,9 one to use with your existing shimmer
or you can buy a 34,9 to use without shimmer
or you can buy a 31,6 dropper and a new 34,9-31,6 shimmer
by the way, I personally will choose 30,9 instead 34,9, the 34,9 Reverb AXS looks really thick, thinner one looks more slim, of course...
I've got both, 34,9mm and 30,9 with shim on the other bike, so far the only difference I can see is the thinner does save some weight. I think thats also the reason SP put 30,9 on high end models and 34,9 on basics
Hi guys, I tried to find the answer on the internet but failed, I’m going to install a light that connect to my motor, my question is, can I just switch off the light to avoid battery drain? Ideally define the f1 or f2 buttons on the control thumb? Looks like if you connect a light and it will...
my frameset came with 34T, yes I did check the SP website again the sworks frameset shows 32T and sworks complete bike shows 34T.
and I do believe this is another typo by specialized, I remember at the time when I changed my MY20 levo to Mullet, the 32T is really not good for 27.5 on the rear.
I think Sram use 6mm hoses, usually the thinner the stronger of brake power, and yes, those sleeves will guide your cable all the way through even cross the rear frame joint part.
yes you can, just swap the internal plugs for each side, each side contains 3 holes, which 2 for large hose and one for remote control.
I did change it all to left side and close up the right side completely with the original cover