Recent content by Deadagain51

I think with shipping it was about £13 so not exactly breaking the bank. I am looking at it as a put me on until canyon and Bosch bring out their update

Depends what they come up with I think, my orbea emtb is only supported by the connector at that end of the battery and has been absolutely fine for the nearly 3 years I have had it, so should be fine if they do it right

What error have you been getting, so far I have had a couple of drive unit - acceleration error messages after a big drop off, etc

A guy on the strive on owners Facebook page (ran by rob rides emtb) has developed a new latch support and is selling them I have ordered one myself so will see if it does the trick

Can you not run the cabling on the inside of the chainstay rather than the outside so you cannot see it as much ?, you could use those small sticky pads that have cable tie anchor points to mount it on the inside without having cable ties on show from the outside (see pic)

Excellent, might look at that in the future if ebiketuner don’t come through. I contacted ebiketuner last week and was told they have a device coming out for the valve magnet smart system in the next few months.

What’s a megabobra ? Is this a tuning device ? Was looking into chipping it but seemed to say they were not available yet for the valve sensor type smart system.

Spot on many thanks. I have ordered the Ltd version as well…how is it !?

Cheers for the confirmation, was planning on doing the same and ordering a spare set. Does it look ok with a 3rd party stem and those spacers on or do they stick out a bit, etc ? If you could put a photo of yours on so I can see how it looks I would appreciate it 👍

That would make sense I suppose, they will do regular shipments to the uk every few days and just bulk the orders onto the next shipment rather than doing each individually

Ordered mine last Tuesday, and it’s now in the uk, with an eta for delivery of this Thursday

Cheers for the info, so I take it the pins on the top spacer fit into the stem that comes with the strive on, but won’t on an aftermarket one ?

Does anyone know if there are any issues replacing the stem with an aftermarket one? The spacers look to be a different shape to the usual round ones you usually have between the headset and stem. Am waiting for my strive on to arrive but am wanting to upgrade the stem and bars quickly

Hi. I am still getting these errors when I go into diagnose and then error, it shows errors 6,5,4,35 & 19.

Searched under LSS and it came back blank