Dado's latest activity

That is normal, you can not see under BT devices. It depends what BT protocol is display using. There is lot of protocols on BT.

Comments mean what It says. ;) 46.4 is for new controller. Throttle with old controllers worked according PAS. New controllers, If I...

With UARTs there were displays which was measuring voltage and calculate SOC. And there were displays you could set nominal battery...

Yes, everyone is looking for such a firmware for M600 to be able to set power levels. Not possible, it is hardcoded in a firmware...

Sisreal, your friend is cheating you. ;)

Hmm, interesting, have not seen yet to reset the settings. After reflashing firmware it is re-set to defaults. Note: I have noticed new...

Okay, so - an update on mine. Replaced controller board, ribbon cable and power board. All powered on fine and worked for about 10mins...

Helo guys. Seems like there is new HW revision of controller FC2.1 and with firmware v3.1

Sticker did change. ;)

And be careful, each 3dB is twice as loud. ;)

I meant some older version of GO+. Somebody wrote here. If LCD firmware v1.2 works then it is great, will try. But assistance level...

You have a display with BT. But not sure now if somebody was able to connect to Go+ over this display. DPC245 v3 works. With older Go+...

Yes think max output is 42v

Yes i bought K1 nice little tool

If somebody wants to try 500W firmware from February... dont have M560 in a bike.