Hyp4r
New Member
Hi Guys
Quite new on here, first post and hoping someone can help.
I have a Kona Remote Control with the Bosch CX motor. Been reading posts regarding applying grease to the drive side motor seal to stop water ingress.Not too sure how to remove the crank, it’s a Sram EX 1 crank, there is a large hex on the cap but there is a smaller hex further in (perhaps self extracting but never seen or worked one before)
Anyone removed one of these? What is the thread rotation?
I do have the tools required.
Quite new on here, first post and hoping someone can help.
I have a Kona Remote Control with the Bosch CX motor. Been reading posts regarding applying grease to the drive side motor seal to stop water ingress.Not too sure how to remove the crank, it’s a Sram EX 1 crank, there is a large hex on the cap but there is a smaller hex further in (perhaps self extracting but never seen or worked one before)
Anyone removed one of these? What is the thread rotation?
I do have the tools required.
