Shimano Ep801 RS upgrade
- Thread starter Ktmkirby
- Start date
There are 3 SD300 ports on the motor. These ports are normally under a very easily removed cover.
But not with the M10. The frame covers these ports, instead of a easily removed cover.
If you have this cockpit. You can unplug the SW-EN600-L switch. Plug in a junction to the cable coming from the motor, then plug your programming cable into the junction. This would be much simpler than dropping the motor.
But not with the M10. The frame covers these ports, instead of a easily removed cover.
If you have this cockpit. You can unplug the SW-EN600-L switch. Plug in a junction to the cable coming from the motor, then plug your programming cable into the junction. This would be much simpler than dropping the motor.
Oh BTW. With no access to your motor ports. I would just get a display installed. They are like 50 grams with the extra cable to go to your switch.
Then use the 4 port connector, and plug the switch back in. You will need an extra SD300 cable.
Oh BTW. If you undid the top 2 motor bolts. The motor should swing down on the rear bolt, and give you access to the ports.
You don't have to drop the motor....... Maybe ......
You don't have to drop the motor....... Maybe ......
Yeah but you can't get to them as the chainring is in the way anyhowOh BTW. If you undid the top 2 motor bolts. The motor should swing down on the rear bolt, and give you access to the ports.
You don't have to drop the motor....... Maybe ......
They know best.
I took my 2023 H10 in for the update and stood by while the girl did it. I’m glad I stuck around, because I figured it out for her. Fortunately this adapter was included with the new stuff they ordered, in order to hook up my bike to their computer. Worked perfectly!
