How to get my motor out?

[EnjOy!]

I want to install my GPS tracker on my bike but I would need to lower my motor a bit and i'm not sure how to do it.
My bike is a "Scott Strike eRIDE 720"

I was thinking it might be these 2 bolts to get the motor out?


This is the connector I need to get out of the motor, the frame is blocking it.

 

[Bearing Man]

There is a third bolt, at the back down the bottom. Then loosen or remove the two T30 torx bolts and be careful not to drop the motor while it's plugged in.

 

[EnjOy!]

There is a third bolt, at the back down the bottom. Then loosen or remove the two T30 torx bolts and be careful not to drop the motor while it's plugged in.

Thank you! Will try it this weekend

 

[EnjOy!]

It worked! Thanks again

 

[games133]

what trcker did you get?