Dengfu E10 Rear Mudguard

[markvanhaze77]

Made this for 29er wheels. Print the main body and then choose the extension you want, short does it for me.
GLue the two parts with a few drops of CA and use a bit of foam where the clamp of the main body touches the frame so it doesnt rattle or scratch.
Use 2 zipties through the holes and you are good to go.

 

[markus datgloi]

Nice mudguard.
I guess printed on a build plate of 300x300 mm in PETG ?
How much space between the tire and the lower part of the guard (zipties) ?
Does the glued part stay in place or does it break off ?

Nothing for the lower linkage arm ( See the solution of Patdam at My Chinese frame and motor build. The CHEEB, V1.0 - Build Thread - EMTB Forums ) ?

 

[Dado]

Hello Mark.

Nice job. Just it needs to go down to the bottom. As down as possible, as this is the problem, mud going into bearings.
Even this length of your guard wont help you to splash on dropper and your ass.

I have one which sits perfectly after little tuning. Check Zefal front fender.