Active Line Plus Gen 3 - SpeedBox 3 - Wiring

[dontcrash]

Hello!

I am planning on installing the SpeedBox 3 chip on my Cube Touring eBike, my versions are as follows:

DISPL	1.4.0.0
DU	1.2.3.0
BAT	1.9.1.0

Assuming that SpeedBox 3 is compatible with these firmware versions?

My bike also has lights fitted from factory.

Here is a photo I took of my bike’s wiring, I am also assuming that these two are where the SpeedBox 3 will plug into on the Active Line Plus Gen 3 motor?

Any advice is greatly appreciated ☺

 

[dontcrash]

Bump: any ideas?
I believe the two indicated plugs are the speed sensor and display but I cannot confirm, I want to ensure I don’t accidentally plug the lights in and blow them.

 

[Rosemount]

 

[dontcrash]

Thanks for the reply but that’s the CX and an older model!
I’m not sure if Bosch have changed their PCB design.

 

[Jackware]

[email protected]

 

[dontcrash]

[email protected]

I have emailed them, but most of the answers I get are “should be compatible” or “should be those two plugs”.

I am after certainty, the last thing I want to do is break my bike ?

 

[Jackware]

That's piss poor for a supplier, however I've just Googled "Bosch active plus motor plugs' and found these images. Don't you just love the internet

 

[dontcrash]

That's piss poor for a supplier, however I've just Googled "Bosch active plus motor plugs' and found these images. Don't you just love the internet


View attachment 37785

View attachment 37788

Wow!! That’s incredibly helpful, I tried googling several things such as “Bosch active line plus PCB” and “Bosch active line plus wiring” but could not find anything useful, who knew plugs was the key word, my Google-Fu was poor, thank you!