Search results

There's been a few posts on the Orbea wild Facebook pages Log into Facebook frame alignment issues

Where did you find this information running brakes at that temperature 230c+ to get that golden heat colour seams a little high

Yes with the correct rim material and stiffness and suitable brake pads some motorcycles are going to a rim type setup for this reason fine until it's deep in mud say like a mountain bike

Larger discs(rotors) have more leverage hence more braking power. It's like getting a 3 foot breaker bar to undo wheel nuts rather than a 1 foot one simple leverage. Another example is fitting the same size discs to 29 or 27.5 or 26 or 24 and so on the smaller wheel with the same size disc will...

2023 H10 standard other than one up carbon handlebars spank split stem 223 front disc photo taken top of Carnmarth in Cornwall looking towards Falmouth

I have some for when I do the next lower leg service on my fox 38 have been using it on my marzocchi 58 for a while seams better in colder weather but that could be just the service

From the blue paper

I initially found the saddle uncomfortable but after a few rides I find it comfortable worth giving it a good few rides first

Right handed left foot forward but trying to get used to doing it both ways

There's a slight drop on the standard stem say 5mm along with a spacer on top when I received the bike if you order from orbea direct you can change it to xt brakes

Try taping a inner cable the pulling it through the outer and let me know how it goes once it's clamped and crimped it very difficult to get in to feed back though the outer far easier to replace the inner wire

It's far easier with a new inner cable having the extra length and a new end that's not frayed

Don't need to touch the outer cable just remove it from the dropper lever and remove the crimp undo the seatpost clamp and put it out with the seatpost then trim outer casing at the bar end refit seatpost with new inner cable

Your best bet is undo the cable and remove the crimp from inner wire pull the seat post out along with the inner wire trim the outer to length use a new inner wire and thead it to the outer down the seat tube this is a bit tricky once the inner is trough connect to the dropper and pull the inner...

34.9 just fitted a wolftooth one to mine

Running hope tech 4 v4 on this talaria sting emoto x with 223 discs front and rear. Can't fault them will put a set them on my e bike soon. And you cannot beat the spare parts available from hope

Back on a ebike after selling my 2021 wild in January to get a talaria sting emoto finding it quite restricted off road other than byways so decided to get this aswell

Seen a few raw carbon frames that have clear coated finish you cad clearly see the facets /layup of the carbon underneath even with a thick clear coat the white one is really bad very poor finish before paint piss poor masking and damage during build. Will be thoroughly inspecting my h10 when...

A hope lower headset will give around 1 mm of extra clearance over the standard one

Totally New wild with 4 sizes rather than the 3 currently available latest bosch motor with GPS tracking built in larger 750wh battery more aggressive geometry . rise is also in for a update carbon will be able to take the larger battery from the alloy version among other changes