Search results for query: *

That sucks. An Orbea could give you any guidance on when batteries would be available or are ghosting you?

You scared me when you said no replacement battery available for a 3yo bike ... you mean not currently available? Part number is XA81, right? One site (Westbrook, UK) says due in on 24/October.

My son has a L Rise and for my 6'4" it's tiny. He's just sort of 6' and L works for him. Go for an XL. By "seat a little high" I assume you mean when saddle is at correct height the grips were too low? Solve that will riser bars and/or a stem with rise. I have an XL Orbea Urrun and...

I have an XL Urrun and installed a dropper post. I'm pretty sure it was a 200mm PNW Loam. They (and most manufacturers) have a calculator. Hope this helps:

It's pretty tight in there, guiding a thin wire through with a magnet is one thing, pulling a thick and stiff cable housing is another. As I wrote above, the first time I dropped (well, flipped bike and lifted) the motor to install the dropper I didn't pull the battery and it was a struggle...

I didn’t see a guide (and honestly didn’t look for one). I just tried to prevent the lines coming down and on top of the battery from tangling/binding when reinserting the battery.

I'm asking the same question on the Bosch forum. I'm wondering what people's experiences are with Bosch and Shimano post-warranty. IMO that's a bigger deal than in-warranty given I intend to ride these bikes indefinitely. I have no horse in this race as I have both a Bosch (gen4...

I'm asking the same question on the Shimano forum. I'm wondering what people's experiences are with Bosch and Shimano post-warranty. IMO that's a bigger deal than in-warranty given I intend to ride these bikes indefinitely. I have no horse in this race as I have both a Bosch (gen4...

So what does GEN4 get ... EMTB+? How does that fit into eco/tour/emtb/turbo scheme (where currently my Rail is eco/tour+/emtb/turbo w/Nyon controller)? I haven't had a firmware upgrade in two years (when motor was replaced) ... have I missed anything? Since the smart system and flow app don't...

Yup that's what I sort of what I have #1 is 150/300/400, max 85nm for the RE, #2 is "fine-tune" max 600 for main battery only. I rode RE almost to the first summit (~1900ft climb); I could have made it if I stuck to 300 but was lazy and ran at 400 for much of the way. 400 seems fine with...

So far so good, used trail (300) on the approach then boost (400) climbing the trail (about 800ft so far). Display @ 8 bars, RE showing 2. Back to Trail for a while. As I recall I can start feeling the drop when RE drops to 1.

The first time I used the range extender after bumping up max power/torque I ran into this on a steep climb. My Urrun had just a few miles on it; I thought I broke it! Off/On then again, then it occurred to me to disconnect the extender, all good after that. I'd consider a new range...

Coyote - big and healthy one. As far as I’m concerned they are a plague. Not so much this guy, his range is wild-slash-natural, but there are a lot than roam the neighborhoods in broad daylight like guilty looking stray dogs. They do keep the small pet population under control. As does the...

On my sunset ride today

[edit: wrote this before reading what backflip wrote. He likely knows more than me :)] I believe eMax modifies the official firmware images to override the speed limiter. Quite a feat to figure out what bits - literally - need to be flipped. That’s why you can’t install the eMax image...

As a precaution I backed out of my max power mod before updating. The blazing fast 32kph we reckless yanks enjoy is plenty quick for me on my emtb, though Orbea runs some of their shimano-powered urban bikes at 45kph.

Not sure if it’s been covered in this thread but there’s a “universal collector” which Enables the use of standard non-OC HS02 stems compatible with round headset spacers. Since the universal collector and standard stems do not have the Spinblock assembly profile, the Spinblock steering...

I’m also curious what the stock power (watts) levels are for the RS+ profiles. I’d have to reset my RS to stock to be sure but I believe the e/t/b levels are 150/250/350w, and 350w being the max for fine tune mode.

I was riding yesterday - only thing unusual was it was a hot day for SF Bay Area (90-100F) but I've ridden the bike @ 106F without issue - Nyon (gen 2) froze so I couldn't change assist level or change screens with the thumb controller. I neglected to check whether the touchscreen responded...

While the Kemen has the same 540wh battery as the Urrun, the Urrun sports the EP801-RS model restricted to 60nm and the Kemen the full 85nm. What I’m curious to know is whether the Kemen’s motor is truly unrestricted and has max power of 600w or if it’s set to something less? And if...