Search results for query: *

Thats good it will cut out. Seen many firmwares which does not cut out at all. ;)) Even with M820 it is reporting in some firmwares funny temperatures.

36V bin file FC4.0

Thats weird, should be the same over 25kmh. It is same hardware drive train.

You can try. ;)) But is very old. And I guess will be set for shunted controller. Be carefull about roll back. You can loose your v76.3 if you dont have it as bin file.

Hello It is 48V and 18A firmware. There is some firmware with 20A And looks like you have some latest firmware, I dont have your v76.3 with FC3.3 Have just 2 firmwares FC3.3 , but I think also FC3.2 would be compatible with your motor (not 100% sure). Last marked is FC3.3 and for 52V.

Fico, that 48V firmwares now works with full 14S voltage and wont give you overvoltage error.

Hello. Not a bad idea... AXS signal must be readable, and need to be able to pair. Avinox can read? Not possible to moderate power, only as you saying over brake signal. Question is if AXS wont be shifting faster than Bafang will process it. ;) That shift and brake sensors also living their...

Ah. This way. :) Yes, that bafang box was just workaround. I think will be integrated on a controller in next RS models. If you dont want problems just go spoke magnet (or magnet on a disc.)

Is a high pitch sound at specific higher rpms. And is weird as I havent notice it in previous version. There was more heard a mechanical noise.

Mate, I wont do anything with that firmware behaviour. :( I have tried to load RS firmware into normal M560, but there was a problems, throttle and speed sensor was not working then. Whats that small PCB? Have you opened small box which is in front of speed sensor? This new speed sensor is...

This one should be for new speed sensor.

Leave there a loop. You can go 5 cm down with the hose and turn back.

Then try to swap that small PCB board with connectors. It is cheap. Also here can be that turn on/off issue.

Check my signature.

It is set in a BBR device. You can go down to 2.85V per cell. Check www.k1ebikes.com You can try Canable software, they have discovered how to manipulate bin file. I am not a big fan of bin manipulation.

Works with every M560 versions. I would go for the latest M560 FC2.0 (new controller iteration and newer firmware in a torque sensor) - hence here we dont have yet firmwares. Only the initial one 48V v60.5 You can be missing just 36V firmware for FC2.0 yet, but this can be fixed by installed...

Patdam, it is just STM32 clone. So every STM32 programmer works (not blue controllers, there was differnt microcomputers).

Neon, what you mean to set voltage? You can not just set voltage. It is about 43V firmware, but is not existing for M56 yet. But you can use 48V firmware with 27 Amps and use 43V battery with BBR. Will work just fine. (Peaking then 1210W electrical) Same with 36V battery. (Peaking 1030W...

Yes, works fine with all Bafang displays. I like DPC245. ;) Some people saying integrated can make some squeking sounds from that hole in top tube. What motor you will have pls? With older motors also ASLS function did work. Automatic set speed limit to 25kmh at each start. Then in M510 and...

Hello Marek. K1 Flash is not dependant on display. You plugging K1 Flash instead of display, set parametrs, or upload firmware. It is stored in a controller and then you can put back your display. There is BBR device and this is listening on a display buttons (magic combination). And here...