Recent content by rotary

I have a cube with the Bosch Gen 4 / kiox display / 750wh battery. I wanted to transfer the parts to a new frame. What frame only options are available on the market ? I'm after something in a large, full sus with modern geometry, 64° Head angle, 470 - 480mm reach etc... Mullet or full 29".

This has been discussed on this forum before but i cant find the thread. I have the following torque figures which i wrote down at the time of reading Motor mounting bolts for aluminium frame = 20Nm Motor mounting bolts for carbon frame = 11Nm smaller bolts which attach brackets to motor =...

Thanks for this

@Dado can supply K1 flash

Yes it can but be careful not to trap any wires internally. I dropped the motor out and stowed the wires properly.

Yes, you need a bearing extractor. The double bearings in the shock linkage are divided in the centre by an internal flange (not visible) so you have to extract them. you can use something like this Small Blind Bearing Extractor, Puller, Remover Tool 8mm 10mm 12mm 15mm 17mm 20mm | eBay

Cheers Jimmy, will take a look, where do you buy the from ?

Thanks Freddy, I've found some 152mm cranks on AliExpress, see what they're like when they arrive (y)

I'm after some shorter cranks (150-155mm) for my M510 motor. What are my options ? I'm currently running the standard Bafang 165mm cranks. Also, please can anyone tell me what the crank mount is ? ISIS etc....

Other than that take the non-drive side plastic cover off the motor (3off T20 torx from memory) and check connections to the motor. If you want to go further drop the motor out and there is one other connection between 2 of the harnesses (forget which) which may also be loose

I’d still try CRC warranty in that case. I read that they’re still honouring any claims. My experience with them has been quite good in the past. Try and get them to send out a replacement keypad.

I'd first of all make sure all the plugs are pushed home into the keypad . Then maybe try and download the Bagfang Go app and search for updates. ERROR description below. 36 = Detection circuit on the keypad has an error 1. Using the BESST tool update the controller to see if this resolves...

MODS, can you make this thread a sticky?

How are you getting on with the jacked up front end? looks nice and slack with the 29" up front. Any concerns regarding head tube integrity? I was thinking of raising my stereo 140 to 170mm fork.

That would make sense. I just saw it on the Bosch website