mike_kelly's latest activity
-
mike_kelly replied to the thread ICR Headsets for the SZZS-specific CEF50 build.Yes -
mike_kelly replied to the thread Building a TSA travel friendly 13s1p battery using 18500 cells..If you do want to do this then Grin is close to you and they know what they are doing. But as noted, airlines are flakey in following...
-
mike_kelly reacted to Waynemarlow's post in the thread Building a TSA travel friendly 13s1p battery using 18500 cells. with
Like.
Be careful with what appears a very limited knowledge of batteries. Can I suggest perhaps doing quite a bit of research into battery... -
mike_kelly replied to the thread SZZS specific CEF50-main thread (initial builds and troubleshooting related only).What kinda travel can the Woom 3 have Here it comes "daddy can I have a ZEB 38 for my birthday?" :)
-
mike_kelly reacted to voigtkampff's post in the thread SZZS specific CEF50-main thread (initial builds and troubleshooting related only) with Like.
As a curiosity, I just used a contraption like in the pic to have a leisure trip with my 4yrs old daughter. Quite ridable setup, she...
-
mike_kelly reacted to TCFlowClyde's post in the thread ICR Headsets for the SZZS-specific CEF50 build with Like.
Yeah, Mike Kelly and a few others are successfully using the entire NP upper headset assembly...so far no complaints have been voiced 💪
-
mike_kelly replied to the thread ICR Headsets for the SZZS-specific CEF50 build.The cup should not need to be glued in. The ZS zero stack cup presses in like any other pressed in cup. Then the bearing just drops in...
-
mike_kelly reacted to LAnton's post in the thread SZZS specific CEF50-main thread (initial builds and troubleshooting related only) with Like.
After the trip, the battery balance is 25%. I have a smart bms. You can easily track the remaining capacity, temperature, cell quality...
-
mike_kelly replied to the thread Building a TSA travel friendly 13s1p battery using 18500 cells..I don't build my own battery packs because it can be dangerous. That said yes you need the full voltage required by the specified motor...
-
mike_kelly reacted to 8Grunf's post in the thread SZZS specific CEF50-main thread (initial builds and troubleshooting related only) with Like.
Friuli-Venezia Giulia :)
-
mike_kelly replied to the thread SZZS specific CEF50-main thread (initial builds and troubleshooting related only).Friuli-Venezia Giulia or Alto Adige?
-
mike_kelly replied to the thread SZZS specific CEF50-main thread (initial builds and troubleshooting related only).I will give you that if you are riding motor out of the design range then 48v is going to allow you to run more into the red zone. The...
-
mike_kelly replied to the thread Shenzhen Zhaosheng Carbon CEF50 Gallery of EMTBforums member builds.@daniele @ficorama
-
-
mike_kelly reacted to 8Grunf's post in the thread SZZS specific CEF50-main thread (initial builds and troubleshooting related only) with Like.
Good morning everyone, I'm writing from the north east of Italy. First I want to thank you for inspiring me in the creation of this...
-
mike_kelly replied to the thread SZZS specific CEF50-main thread (initial builds and troubleshooting related only).neither the Shimano e8000 nor the EP8 is a full size motor. The Bafang 620 is a full size motor. The effect of the heat and how it is...
