Recent content by mgx

Battery and LID are separate. Lighter battery does not make any sense IMHO. If yes, you need full battery, but inside it will be somehow reduced. You can contact Dengfu for advisory or buy a chinese batterybracket and build your own with BMS onboard. Make no sense. Or what is more recommended...

Sure, its this one CRX10NC4818i132046.7-28-2230-20201121.bin when downloading, click on RAW button on right to download bin file and not something wrong. Also confirm with checksum (if using Total commander -> menu Files->Verify checksums. Other confirmation is when editing bin file in HEX...

I suggest try 46.7, i think its closest to your requirements... If not, then 46.8...

its not possible. Power curve is not a one byte, fw has checsum and binary adjustment is 100% way for controller brick.

I dont know this fw, can you share the link? Then i can compare with diff. I was refering to https://github.com/OpenSourceEBike/Bafang_M500_M600/tree/main/Firmwares/Custom/Motor/m600 when downloading make sure that you download correct version, which is RAW. size of file must be matching...

stock_x1_firmware__11007_14.6.bin is more-less same as Bafang 14.6 fw i believe. Meaning, strong PAS1-3 modes, good start. I dont know if you will like it, because i think PAS1-3 are very powerfull here. Ideally you flash and try what you like most. I did here a comparison a fw, if you search...

Luna detuned fw for M600 I'm looking for a software which in best case all the params could be changed with BESST Pro. For M600 this is not possible. You need to use 510 or 615 motor with controller which allows that.

Hello, then puzzle is solved. with M600 you can safely use Luna fw (i have installed it yesterday to one of client) with M600 and 500FC 3.2. You can try Bafang 1.2.43, if it will not work, i will share link to older sw release. Follow instructions posted in this thread by me earlier. Version...

Hello, below 4 fw are safe to use: yoiu can download from link repository on some posts above. Based on controller (500.FC 3.2) i think, you can use also Luna fw (detuned) or ask somebody who has M500 motor with detuned fw. This usually has lower amps on stage1. But carefull, luna FW is for...

also make screenshot from current fw you are using.

Hello @marcelmmx Firmwares for M500 are located here: https://github.com/OpenSourceEBike/Bafang_M500_M600/tree/main/Firmwares/Official/Motor/m500 I dont use them, ask @KyokushinPL for advise, as i suppose he use them. Granular ramp on M500 is normal, its weak motor. Try to check linked...

Try this luna fw, its detuned. First sent us current best screenshot from your current fw, so we can check your controller compability.

same

dont know, never used it :) i was sticked to 46.6, and 46.9 is on my to-do-list. But i do prefere lowest PAS1 possible now and near zero gap /delay when power on-/power-off the motor.

I tried today this one on M600, PAS1 is weaker then 46.6.