Recent content by JonoHobart

I just wished they’d tell us this directly. I have contacted the engineers via support, and it seems to be the party line not to mention anything about anything happening at the motor end. I have a colleague with the same bike as mine who has had now two replacement motors for the same...

I smell a rat and I can’t understand why these motors are being replaced rather than just a sensor or sensor cable. Clearly there is something more sinister within the engine electronics at play that can’t be swapped out. I wonder if they are working on a completely new Setup and just too scared...

Has anybody actually been told why they need a new motor and what specifically has been the problem? I have had no luck even with flow engineering support in them being able to tell me anything that seems to be ever wrong with the Motors that they have had returned. They continue to sprout...

I have a friend who believe it or not we’re not able to solve the error message by all the usual shenanigans had his motor replaced. That was only about eight weeks ago, yet today after replacing brake pads cleaning disc rotor And reassembling. He went for a short ride only to find the error...

Anyone know if there are any rental shops in the Dolomites or Finale Ligure region that could supply an Avinox powered MTB for a week?

Sort of bizarre to think that you are not permitted to understand what the issue is with your bike, (one that you own and is your property and responsibility, and not some corporate owned entity), and told to wait till you get home from a trail, get to an internet support line then wait for a...

Unfortunately, no matter which PDF document I see in the manuals there are no sections that appear to have error codes. Am I missing something?

Can you point me to a link or list of error codes or symbols that might appear on the screen. A friend of mine reports to me about a red or orange triangle with some words inscribed that he says disappears when he stops riding and so he’s not able to tell me what they say! It seems that his...

Thank you. After removing the UDH, I’ve noted that cinching the bolt leaves some side to side wiggle. it probably would tight right up with the skewer tightening, but the threaded bolt seems to stop before I would ever be able to put 35NM on it. Should there be an extra washer in there? ( yes I...

Were you able to get one easily?

Hi there, it might seem unusual given I purchased a mechanical PL Carbon, but has anyone had any issues with replacing rear derailleur with sram eagle GX T type? (obviously swapping chain and mech shifters). Is it just a case of removing old hanger and fitting T type?

Thanks, I’ll await any further advice from others before jumping into buying a new cassette. Apparently XD freehubs are in the order of AUD70, but that of course assumes you might be swapping like for like, as you say, not sure if you can do an automatic swap for the HG free hub body.

Thanks. Pretty much what I thought, but does it have to be Amflow wheel specific, or can it be any SRAM XD freehub body?

Can anybody tell me if I need to change the free hub body on the PL carbon version, ( Amflow HMA-30 wheelset) If I am going to put on a SRAM 1295 10 to 52 tooth cassette? I am considering upgrading to T type AXS transmission given that I already own a rear derailleur and the shifter.

I have led you a bit astray with my last request. its 25 km/hr ( not 250 watts) and 500Wmax output. see wording from my policy: • “Electric bicycles (E-bikes) that are electric “pedal-assist” or “pedelec” with a maximum power output of 500 watts and maximum assisted speed of 25 km/hour. However...