Recent content by hainman

  1. H

    Whyte e160 RS 2023 controller issue

    So my mates e160 with smart system controller developed an issue yesterday He downloaded the Flow app and was trying to pair the bike to the app The Controller is just cycling through the blue led lights then off again Bike unable to switch on to see what the issue is He got the bike to a whyte...
  2. H

    MET Parachute MCR

    One of the comfiest lids I’ve used Even with chinbar off it’s great
  3. H

    DVO Jade coil 210x55

    Eventually went with a Springdex for a bit of progression and some adjustment
  4. H

    Best upgrades to Zeb base model?

    Would the smash loot fit on a set of Domains?? Same chassis as the Zebs I think
  5. H

    DVO Jade coil 210x55

    Awesome Steve cheers
  6. H

    DVO Jade coil 210x55

    Hey Steve Thanks for the Reply So my Q was more in regards to if the spring rate of 65 would fit as the spring rate should be 55 Been told 55/65 is much the same as in travel but wondering if the spring would be awkward to fit with it being 10mm long maybe
  7. H

    DVO Jade coil 210x55

    Just picked up a DVO jade for my whyte E160 and not sure whether I need to put a 55 or 65 stroke spring on I know the stroke is 55 but someone said ye can run 65 but nog 💯 sure what this would achieve or feel like on the bike Any info would be greatly appreciated
  8. H

    Old topic. Bosch Gen 4 motors

    Just had my bearings and service done at £180 so I’ll keep this in mind for next service Can’t afford another £190 on top but cheers
  9. H

    Old topic. Bosch Gen 4 motors

    Just had my motor serviced but the crankshaft bushing has failed and shop couldn’t find a replacement Quite a bit of play in crankshaft/cranks Guy done as good a job as he could to get it back to as close to working Has anyone had the bushing replaced and also where do you buy the seals??
  10. H

    Bosch Gen4 Seal Service & Grease up

    I ride in Scotland 90% or my riding is in the wet and Mud
  11. H

    Bosch Gen4 Seal Service & Grease up

    @Bearing Man whats the price for a full service on the Bosch gen4 motor My last bike I had to get crankshaft bearings done and there was wear on the shaft which caused a slight bit of play when you move the crankshaft side to side Don’t have as much issue on this motor,wondering if doing a lot...
  12. H

    Front tyre for mud?

    How do the Hillbilly’s cope with Root n Rock??
  13. H

    Michelin E-Wild 2.6 tyres.

    I put a hole in an E-wild on my rear and that was with a rimpact I’m now using tough casing WGB Judge
  14. H

    What tyres? The Ultimate Tyre Thread

    What version of the verdict are you running
  15. H

    What tyres? The Ultimate Tyre Thread

    I live in Scotland so all I’ve the above,and sometimes in the same day😭
Back
Top