Recent content by GrandesRoues

It's like that on small frames.

Some info here : https://bikerumor.com/bosch-cx-race-limited-edition-motor-gets-exclusive-400-assist-race-mode/ Same chassis, new race motor for one model.

This pict was taken with the same extrem position (12 o clock), left is stock part, right is Slash 72° kit. One can see the difference in turning radius. On the Slash kit i bought, both the top cap and the little part screwed on the frame are different. Top cap have an inside circular...

So i installed the new headset. It required some dremel work. Stock parts on the right, new parts (Slash 72° kit) on the left. The result : a better turning radius, and still knock block to prevent the bar from over rotating.

Hello, I'm interested in the new analog trek Ex, and went to Trek-s website project one https://www.trekbikes.com/us/en_US/project-one/ For the Fuel Ex, it is written "Currently Sold Out. New product available Fall 2022". Indeed the new model (close to the electric Exe version) has just been...

Buy some inserts (Tannus tubeless for example), and use lower pressures !

Somes news, i received a new hub for free. Even if it wasn't under guaranty anymore ! I had my whellbuilder build back the whell, and i'm riding again ! I have the 72° headset, and the aenomally switchgrade to install, and will report. I still don't like the Magura MT8 brakes. The braking is...

Si, if one just remove the blue spacer, the spring rate would be more linear ?

Survey was a bit strange, i didn't quite know what to answer in some places. For example -i use the TOUR mode, witch is not an option. I didn't like the TOUR+, because at 90kg i produce some power and so have the assistance always at the strongest, draining battery. It's the same in eMTB, with...

That why you need the medieval full body armor :cool: Or may be you could use this : o_O:giggle:

You Californian guys might need to get back to old French traditional clothes :-P

If one cut the spacer with a Dremel, do you think it could be removed without braking it ? If it's broken, may be one could 3D print 2 "C" shaped parts that lock together (with some pin), and glue them... @JMD I have an XL 2021 carbon also. Did you do the mod on yours ? With the minolink in high ?

So, did someone put a 30T or 32T on his Bosch crankset ?

-The rear hub will be changed by the manufacturer (even if out of warranty), but there is some waiting time -i ordered an Aenomaly Switchgrade (end of march, no sign of shipping yet), we will see if it helps on step inclines -I found in Spain a 72° knock block assembly, i ordered it, we will see...

I have seen some picture of a new casting on some Enduro pro bike. Look like relieve valves in the back like on the fox 38. For 2023 may be ?