Hey @Bearing Man, thanks a lot for this information! Finally found it here. Just to confirm, are the part numbers on the bottom right (the mounting plates) for the BDU4XX unit? I found that my drive-side bottom plate is stripped (on my 2022 Trek Rail), and have been looking for the right part...
Thank you! Im actually taking the MT7’s off my Slash and onto my Rail…I love these brakes, other than the pain in the ass it is to get the calipers properly aligned, almost a surgical job hahaha.
Thanks again!
Thanks! I’m also upgrading to MT7’s…I didn’t realize I need to drop the motor too, I thought there was a channel for the hose to go through, but apparently not 😱
Any other tips before I get the tools out and start disassembling this thing? Hahaha
Hi there! I'm upgrading my Rail's brakes (and other things) and need to access the internal cables which are below the battery alignment rib...am I right to think that all I need to do to remove the rib is remove the 4 T25 security screws holding it (and then open up the clamps holding the...
Didn't know that, thanks! Just looked at fox's website and changing those spacers looks like a very simple job. Guess I'll go with 62.5 then, and reduce travel if needed.
So final confirmation: the DHX2 will fit on a 2022 Rail 7 (size Large)? I suppose geometry didn't change from the 2021...
Hi everyone! New to the forum, and new to e-bikes as well with a new 2022 Rail 7. I've owned a Slash for a few years now and when compared to the Rail, my only complaint is the shock on the Rail...so, before I pull the trigger, I just wanted to make sure my plan will work: replace the shock with...
Bumping this up, had the exact same question! I'm assuming you can just use a standard UHD, otherwise it's no longer a proper "universal" hanger...but in this industry you kind of never know, hehe