Bafang M400

[PitcairN]

Hi guys, does anyone tested if M400 motor with UART bus can be modified with Bafang config tool? The same one used for modifying BBS engines. thanks.

 

[eCologne]

Yes. Me; since years.
I do have a 250W and 350W controller for my M400 UART motor.

At the 350W Controller I can give 20Ampere at 36Volt. In the woods it makes fun!
You can change every assist level.
If you want, give 100% power at level 3 and 50% power at level 4; makes no sense, but possible
I changes the SpeedLimit, too.

The M400 UART works with the EggRider Display, too.

A heavy, but good motor. Bought a 2 second one spare. And 2 second 350Watt controller (last month)

 

[PitcairN]

Yes. Me; since years.
I do have a 250W and 350W controller for my M400 UART motor.

At the 350W Controller I can give 20Ampere at 36Volt. In the woods it makes fun!
You can change every assist level.
If you want, give 100% power at level 3 and 50% power at level 4; makes no sense, but possible
I changes the SpeedLimit, too.

The M400 UART works with the EggRider Display, too.

A heavy, but good motor. Bought a 2 second one spare. And 2 second 350Watt controller (last month)

That's great news! I must give it a try, many thanks.

 

[eCologne]

And? Does it work?

 

[PitcairN]

And? Does it work?

Hi, sorry for the late answer. Of course it works! I was able to change the speed limit for one customer by bypassing the display speed command setting. It still shows 25 km/h limit on HMI but in reality it supports up to 40 km/h, which is pretty awesome. Display was not supported by Besst - i was unable to read it. You can change many parameters similar like with BBS02B/HD motors. Cheers.

 

[geomix89]

Hi,
which Bafang aoftware should I use for changing the values?
The same as for the PAS-motors (BBS02 and BBSHD) or a torque sensor specific software?
Thanks!