trey_eng
New Member
Thanks for letting me join you forum.
I'm looking for some repair advice for my Bafang M600.
I have a situation where with a full battery everything works fine. After riding for an hour or so if I shut the power off or it shuts off automatically after 5 minutes, when I turn it back on I get a Error 25 - Torque sensor error. I've pulled everything apart, checked all my connectors. Everything appears to be seated correctly.
When I run the BESST tool I can run the Controller Position Calibration successful, however when I run the Torque Sensor Calibration, nothing happens. I only have assembler rights so not sure if I have rights to run the calibration.
I think my real question is, do I have a torque sensor issue or a controller issue?
Any help here would be appreciated.
I'm looking for some repair advice for my Bafang M600.
I have a situation where with a full battery everything works fine. After riding for an hour or so if I shut the power off or it shuts off automatically after 5 minutes, when I turn it back on I get a Error 25 - Torque sensor error. I've pulled everything apart, checked all my connectors. Everything appears to be seated correctly.
When I run the BESST tool I can run the Controller Position Calibration successful, however when I run the Torque Sensor Calibration, nothing happens. I only have assembler rights so not sure if I have rights to run the calibration.
I think my real question is, do I have a torque sensor issue or a controller issue?
Any help here would be appreciated.
