• How to use this section. To the thread starter: Once you are satisfied with the answer that youve been given, click the Trophy on the left hand side of the message. This will rate this answer as the 'Best Answer' and will change the question status from 'Unanswerd' to 'Answered'. All members can also upvote an answer with the 'Up' arrow, this will help identify the best answer.

Answered Do these Miranda crank arms fit on my Haibike Sduro Full Fat Six?

eFat

Active member
Founding Member
Feb 4, 2018
342
270
Switzerland
There is no information about the q-factor so I would say no.

Look at Miranda website to find the correct one.

You have to check these 2 measurements:
crank-png.2096

a is either 10.5mm or 16mm. The longest may be needed to clear the motor cover.
b must be enough to clear the rear frame triangle. I would think that on your bike it's not the same on both sides.

And you should check the motor interface, is this ISIS or square?
 
Last edited:

EMTB Forums

Since 2018

The World's largest electric mountain bike community.

518K
Messages
25,449
Members
Join Our Community

Latest articles


Top