• How to use this section. To the thread starter: Once you are satisfied with the answer that youve been given, click the Trophy on the left hand side of the message. This will rate this answer as the 'Best Answer' and will change the question status from 'Unanswerd' to 'Answered'. All members can also upvote an answer with the 'Up' arrow, this will help identify the best answer.

Back Pedal Tool - Chain Cleaning

Paul L.

Member
Nov 30, 2022
9
4
North Georgia
I am 2 months into owning a Canyon Spectral:ON. I could not find a good way to back pedal to clean and lube the chain so I made the tool below.
Tool 1.jpg

The tool is a short piece of wood with two bolts thru it. I used a long carriage bolt which I wrapped with duct tape. This bolt fits in the center hole of the crank. The shorter bolt fits thru the chain ring and I used heat shrink to prevent scratching the chain ring. The scrap of 1/8 inch wood fits between the short bolt and the crank arm and you pull it out when you are done to make removing the tool easy. The picture below shows the tool assembled for use.
Tool 2.jpg
 

EMTB Forums

Since 2018

The World's largest electric mountain bike community.

518K
Messages
25,449
Members
Join Our Community

Latest articles


Top