Search results

LBS activated the waranty. hopefully will receive it next week.

connectors cleaned. doesnt work. Not-so-localBIKEshop asked me to send it by courrier.

No fuse in the plug. And tested the friends charger on same plug and worked.

The charger doesnt turn on. No light. A friends charger charge the bike perfectly. Also exchanged the cable that powers charger and nothing.

Hi, the bike was charging and suddendly the charger turned off. Charged up to 93%. Bike is updated. Limit charge was not enabled. Charger isnt hot, normal temp. Anyone experienced a similiar situation?

Ok, thank you for all inputs. I share pictures of the setup i got. Not sure if the mount will be strong as it clearly was planned for a thinner handlebar but the garmin gets reasonably centered and i get the light on the correct position. Hope you find usefull.

I make sure to switch to e-bike mode immediately after switching it on. If you prefer to have the light always on then you can just leave it on in e-bike mode and it will always be on. I think the faults occur when the e-bike tries to modulate the voltage output when the light is not in e-bike...

My first ride with the light, daytime. It turned the bike off after some kms when climbing. Error message on the tcu. Light also off. Turn bike on again and made sure the light was on emtb mode (pressing 10sec until button flashed red) and mase 40kms more without a problem.

Yes, i am trying to find a way the light gets even closer to the garmin advance mount. Similar to that of yours.

Light installed. Quick test and seems to work flaulessly. immediatly setup to ebike mode as recomended. now busy finding a proper way to use both the garmin and the light in such a way they both get centered and witrh good looking!!

I make sure to switch to e-bike mode immediately after switching it on. If you prefer to have the light always on then you can just leave it on in e-bike mode and it will always be on. I think the faults occur when the e-bike tries to modulate the voltage output when the light is not in e-bike...

I have the MJ-906S wired directly to my Gen 3 Levo. It works fine. I manually toggle between e-bike mode and standard mode. I leave it turned off 99.99% of the time via standard mode. Then if I need light, I turn it on and switch to e-Bike mode by holding the button for 8 seconds. It's...

Yes I covered up the light sensor. It also gave some motor errors in mission control mentioning that it’s trying to draw too much power :-( Does anybody tried the MJ-906S with Gen3 turbo levo? does it work?

I received an email advising of an update. Dind care much but the bike started showing error messages and turning itself off. Went to the LBS and they said the missing upgrade was probably the cause. Did that and till now no more turning off or error messages. This upgrade had to be done at LBS...