There isn't one! The video I saw was for Gen3 - thought it'd be close - its wasn't! Thats what made the job so scary - just winged it!
I ended up having to take the motor core out to get to the bolts holding one of the shaft sensors in place - this can't be right can it?
Its been running fine...
Hi,
I have just started to get the same problem.
Power the controller on, motor wuuuuurs for a second then the whole thing powers off. The duration of the wurrrr gets shorter and shorter each time I repeat it (say 10 secs between) . If I let it rest/remove battery then try again, the cycle...
Probably wise advice. I've seen the video and it almost dissuaded me.
I purchased the two crank bearings from them last week.
I'm an engineer and have a good drill press (almost hydraulic) - all the gear and no idea!
I emailed them asked if they were busy - they were on holiday for a couple of...
Spent time looking for the tool needed to remove the chainring nut as shown in the first picture of this thread.
The 'official' bosch part is priced between £30-£45.
There is an alternative at £15, that I've got and used; IceToolz BB Tool, 8-notch, Shimano / ISIS Drive, #11D3
I think any ISIS 8...