Have to do the twice on different Besst. Set speed to below 27 and adjust parameters on Pro. Exit and proceed to old beest to raised speed. Its PITA but thats the only possible at the moment. Unless you have a superuser account login.
It also increase the ramp up at 0 degrees which is extremely annoying. You won’t be able to ratchet your crank like an analogue bike when experiencing a rough uphill switchback on the trails
You could be right. Its probably the support level between PAS which is inconsistent. From my M560, i found out that if I set the same support level for PAS 1 & 2 it produces a very linear and smooth transition.
I have the review on facebook. Basically a much smoother motor and the availability to dialed down the cycling parameters is a gem. Only issue its noisy compared to the synthetic peek gear on the m600. Other than that, its a huge improvement over the M600.
I used this before my M600 died. It has a milder ramp up but has a huge gap between Pas 1 & 2. Pas 2 is too much power and ramps higher. Pas 2 will gets you almost anywhere just the ramp up is too abrupt. The M560 on the other hand is so much smoother and adjustable.
Interestingly, the startup angle is tied to factory setting of speed limit. I was unable to adjust it until i change the speed limit to 25 via Beest and then change the straup angle and back to speed limit via Besst. Strange.