Wojtek's latest activity

  • Wojtek
    Wojtek reacted to Rando_12345's post in the thread New Amflow Models? with Like Like.
    I've seen a few tests say they didn't even get 1000m of climbing from the new system in higher modes. So yes, definitely would like less...
  • Wojtek
    Wojtek replied to the thread Amflow general questions and answers.
    Oh ok. I was just curious if it was only here with the delay in answering. Good to know they answer quick via direct message
  • Wojtek
    Wojtek replied to the thread Avinox M2.
    The Avinox motor runs on a 36V system. To hit that voltage with these 4680 cells, you MUST have 10 cells connected in a single row...
  • Wojtek
    Wojtek replied to the thread Amflow general questions and answers.
    No response from Amflow for over a month. Thats a bit concerning. Understood the new models coming out, but with so many new brands out...
  • Wojtek
    Wojtek reacted to Petrex's post in the thread Avinox M2 with Like Like.
    Hmmm! Didn't see that bit on the PX splash page. Not mentioned on the PX spec. page. The PR spec. page has the info that I quoted from...
  • Wojtek
    Wojtek replied to the thread Avinox launch 1500w M2S motor and cheaper M2 motor.
    Only 1300w 🫠
  • Wojtek
    Wojtek replied to the thread Avinox M2.
    Rumours say 936wh molicell battery in certification phase.
  • Wojtek
    Wojtek replied to the thread Avinox M2.
    And all youtube videos SHOUT 1500W 😀😀😀
  • Wojtek
    Wojtek replied to the thread Avinox M2.
    Why did they increase the power then? Nobody asked for it! 🤣 Last thing everyone wants is fear of illegitimising the ebikes and having...
  • Wojtek
    Wojtek replied to the thread Avinox M2.
    Having so much power in PX and needing to save battery is a bit sad. Too much range anxiety for my taste 😀 Might go with PR with dual...
  • Wojtek
    Wojtek reacted to Petrex's post in the thread Avinox M2 with Like Like.
    The new cells allow constant 1500W, not just 1500W Boost mode. https://ebike-mtb.com/en/avinox-m2-test-dji/#5 "The M2S can sustain its...
  • Wojtek
    Wojtek replied to the thread New Amflow Models?.
    Nothing official.
  • Wojtek
    Wojtek replied to the thread Avinox M2.
    PR removeable doesnt reduce the peak power - it is at 1500W whereas the older ones are reduced to 1300W. Hence my initial assumption. It...
  • Wojtek
    Wojtek replied to the thread Avinox M2.
    Looks like PR pro matches exaxtly PX non-pro in terms of components. Only difference being the battery. Not sure about...
  • Wojtek
    Wojtek replied to the thread Avinox M2.
    Thanks ! I guess the battery cells for PR are different than for PX and different than for older PL..
Show older items
Back
Top