Waynemarlow's latest activity

  • W
    Waynemarlow replied to the thread Bafang m510.
    Sounds as though the outer seal is worn and letting in water though the seal, on through that outer bearing and then onto the main...
  • W
    Waynemarlow replied to the thread Bafang m510.
    If water has entered the motor then you may need to replace the ribbon cable ( usual symptom of the ribbon cable failure is the motor...
  • W
    Waynemarlow replied to the thread Bafang m510.
    Err30 is normally a fault between the display and motor. I get it sometimes if the connector becomes ever so slightly pulled out of the...
  • W
    Waynemarlow replied to the thread Bafang m510.
    That looks normal as the seal pushes in from within the case. You need to measure the distance from the position where the spider sits...
  • W
    Waynemarlow replied to the thread Bafang m510.
    Be a bit careful with the spiders that do not have that wide flat just beyond the engine case. I tend to have an engine failure each...
  • W
    Waynemarlow replied to the thread Bafang m820.
    The EBICS M820 version starts here...
  • W
    Waynemarlow replied to the thread Bafang m820.
    It comes up max figure, I can’t remember what the figure was. On the EBICS thread only the controller has a temp sensor and not the...
  • W
    Waynemarlow replied to the thread Bafang m820.
    As you know your widget won't display the controller temp on the DPC245's as discussed with you. Bafang doesn't display the controller...
  • W
    Waynemarlow replied to the thread Bafang m820.
    The EBICS developer has already discovered the power limitation of the M820 controller board, that of only having 6 FETs handling the...
  • W
    Waynemarlow replied to the thread GOBAO ECVT EMTB Mid-Drive Motor.
    Can we wait until we get some actual trail time in before making those sort of assumptions. I would doubt there will be much ride time...
  • W
    Waynemarlow replied to the thread Bafang M510 RS - discussion, tuning, firmwares.
    Efficiency will be probably similar to the Pinion as any energy has to be used by either heat ( friction ) or transferred to the output...
  • W
    Waynemarlow replied to the thread GOBAO ECVT EMTB Mid-Drive Motor.
    The only way energy could be lost from the smaller motor is through heat (friction ) or for its energy to be absorbed in helping the...
  • W
    Waynemarlow replied to the thread Dengfu E10 + E23 Carbon Fullsuspension E-Fatbike on Bafang M510.
    Same in the UK with all the mud and grit damaging that one drive side seal on a too regular basis. I've taken a slightly different...
  • W
    Waynemarlow replied to the thread Bafang m510.
    Be interesting to do say 200miles and then compare the motor noise. My M560 is definitely quietening down compared to new as did the...
  • W
    Waynemarlow replied to the thread Bafang M560 FC2.0.
    Mine is only a few months old and supposedly the Quiet version but annoyingly loud at higher rpm. I’ve done a couple hundred clicks on...
Show older items
Back
Top