Recent content by Steve h

Thanks, I had convinced myself it was the chainring! I also ordered the correct socket at the same time as the chainring! Ouch!!

Hi all, I’ve just replaced the chain on my alltrail 6 and now I’m getting a lot grinding/ crunching noise when the bike is under load! The more pressure on the pedals the worse it gets. It only been like this since I replaced the chain, so I’m thinking I need to replace the chainring? Also has...

I believe that you plug it into the Flyon display. If you take the cover of where the cables go into the display there is a spare cable port.

Yes you need to remove those plates to access the bolts and cables. Nothing falls out when you remove them.

I’ve fitted these to mine, yep the wires are in the frame ready to connect. They are secured with a small alan bolt. Very fiddly to get the bolt in! I ended up cutting a alan key down so that the short leg was very short.

I had exactly the same feelings when I bought my Flyon Alltrail6 3 months ago! Cable rattles, creaking crank and why did I buy a hardtail!!! I also hadn’t purchased from a local dealer! The local Haibike dealer just wanted to sell me a Cube (which are nice) but I wanted the the power of the...

Installation was relatively easy, only issue was I needed to push the connectors a bit firmer together, first trip out I kept getting an error message. Has been fine since I redid the connectors. About 100miles with it fitted so far. The only other thing to watch is the O ring style gasket on...

No I didn’t. To be honest it never crossed my mind!! I did spray the connectors with water repellent designed for electrical connections though. Be careful when putting the motor back in to make sure the gasket is seated properly.

I have the bikespeed rs chip on my alltrail 6 and it works fine. Weirdly I’m getting better mileage out of the battery. Didn’t expect that! Had a few issues to start though but this turned out to be the plugs! Just make sure they are well and truly pushed together!

Thanks for posting. At least I know what it is if it happens on mine. Especially after the grief it’s given you!! Glad it’s sorted for you now.

Haibike Alltrail 6.

I can’t believe they couldn’t have fitted a stem that would have allowed clearance for the display bracket!! Does seem to be a design issue! I’m thinking of containing Haibike direct. On a positive note, now I’ve done 400miles on it, the motor is quieter!

I have spoken to my bike shop about this and they have said that Haibike dropped the steering stop due to safety concerns!

By tightening the cranks, motor and stem bolts it has cured it for about 30 minutes until it all starts moving again. I need to get some thread lock! Also sounds like I have a loose cable in the tube now!? What I’m really pissed about is I hit a rock on a narley climb this morning which through...

This might have stopped the damage to my top tube when the dropper lever hit it when the handle bars swung around!