A quick ride report, as I put in a 40km ride over varied terrain including some steepish climbing, roads, gravel/dirt tracks, roots, mud sand and water crossings, but nothing particularly technical.
As this is an Emtb forum: battery stats first. 34% used (64% remaining) based on actual resting...
Review Part 1: Assembly, first impressions
I've received bikes in a box before, and the Reid unpack and assemble experience was fairly typical. Lots of open space required, mainly to stash all the removed packaging. Everything arrived well padded and it took about 10 minutes to remove all the...
I've recently purchased a Reid E-Trail 2.0. It uses the Ananda D10 display, but the programming has been customised to suit the bike. I've put together a revised set of display/control instructions which are attached as a PDF and may be useful for some, as the bike itself is short on...
Hello to all.
Introduction: Retired tinkerer mainly with bikes, hang gliders, 3D printing and DIY electronics, not necessarily in that order.
E-bike experience: I've done 3 e-bike conversions - (front and rear hubs and a mid drive) and have just purchased a Reid E-trail 2.0 and am in the...