Recent content by nathan_dh

Size Large, Storia V4 205x65mm full Compression. PRO Flip Chip positon

Size Large, Storia V4 205x65mm full Compression. STD Flip Chip positon

Where did you order it? Velduro UK cant sell me one. Veloeggä in Swiss dosent have/get one

Today I loosened the motor bolts on my bike again and re torqued them to 25 Nm. So far, the noise is gone. I have only tested it while stationary. I will see how it is on the next ride.

Check ALL bolts. 99% of mine were loose. Also, if you have the time, grease the pivot bolts. Some are greased, some are not.

I think there was not enough thread engaged.

Size L & M are stock in Swiss. With or without Shock. VELDURO ROGUE Frame Only powered by Avinox M2s

No, I rode the mech for about 1,000 km with no issues at all. I have already set it up twice according to Sram. I’ll test the setup in gear 7. Maybe that helps.

@Rob Rides EMTB & anyone else. How did you set up your Transmission? I set it up according to SRAM in gear 6, setup key A, with a 124-link chain. But my shifting is bad, and in gears 7–10 my chain is jumping weirdly. Micro-clicks are correct. I ran the same X0 setup on my previous bike without...

Does anyone have an official fix for the motor creaking? Mine creaks badly. There were no shims installed from the factory. Bolts and motor contact points are greased and torqued to spec. A video of the creaking is attached in the Google Drive link:

New Build with the Intend Moto V2. Weight 23.52kg Specs: - Rogue Size L - Intend Moto V2. 180mm / 65mm - Intend Trinity DH / 220mm Hope CL Rotors - Sram XO Transmission connectet to the Avinox Motor - Custom Carbon Wheelset with Berdspokes & Erase V2 Hubs. Mullet - One Up Pedals. Yeah, I know...

So, I was able to test the Hove MC in size M. At full bottom out, it touches the charging port cover a little. It might be worse under hard compression when the frame flexes. But I think you’re good. I also took the bottom out rubber ring off for the test. With the bottom out ring, it will stop...

if u install it for me yeah sure:ROFLMAO: i hate to do it

I orderd a size large. Yeah its worse with the Opt. If you’re 100% sure you would order the Hover Monocoque, I could maybe test it on a size medium for you, with 205×65mm or 205x60mm. I tested it with my Moto V2 (aka Rover). But the Body is the same as the Hover Monocoque

I’m guessing you have no update on your frame delivery? Im on the same Batch. I have to bring my Hover Shock to Intend before I can fit it to the new frame. But then I can’t ride it on my current e-bike after the changes, which sucks if I do it too early. But if the frame arrives sooner than...