Recent content by KKe

One tip is check your cable lengths. I was able to replace controller cable of my Wild size M from 1500mm to 1000mm. Motor power cable from 400mm to 300mm. This saved about 25g and in theory may even increase performance. Replace Bosch rim magnet with 15x6x6mm neodym ring magnet. That will save...

RXF38 is quite light with air spring, around 2300g. When you add coil, its bit above 2500g, depending of spring rate. Podium is north of 2700g as standard.

This is installed top of the stock guard?

Please give community data on Öhlins coil versus air versions and TF Tuning options.

I can admit that my stock cover have last several quite hard hits just fine. Its made from softer type of plastic that may not crack very easy. Haven't seen many phots of broken ones. Adding that alu is for sure more robust but could hang even lower. No brainer if stock fails constantly. Nice...

I believe that stock guard could be stronger. Wolfcarbon is bit lighter and looks nice. There is lip on left side that protects motor heatsink that stock one doesn't have, it may affect cooling. Fitment was good. Time will tell how long it will last.

Weight is correct. Taken with checked Feedback scale. It shows +40g @20kg.

Thanks. I can't give any opinion of fork yet. I just did short run-in ride today, and its still quite icy here on trails. I would definitely like to try TTX22 coil on the bike.

My Wild on version 2, after complete rebuilt. New front frame and Öhlins suspension. Some other smaller upgrades too. Weight is now 21.00kg even. That is with coil fork and with pedals. With air spring in and without pedals it would be 20.42kg. Picture from this sunny morning, now it's muddy:D...

Thanks. Better resolution close up picture of this bolt should show it. On bluebook they list old model still, but may just not be updated there. There have been lots of reports of these old type Bosch bushings falling out on other brands like Cube. Have not heard before from Wild, mine have...

Could someone with 2026 carbon Wild help? Does Orbea use these new type of motor mounting bolts on 2026 models? Close up picture from left side of motor would tell this. Bluebook still shows old bushing type, but it is based to 2025, so may not be updated on this.

1. 34T is on stock, it is pretty much standard choice now days. So not too much. 2. You are 184cm so you are fine. I have 180mm V3 on M frame. It can be inserted flush. But I'm much shorter than you and i need to raise it from flush. I would choose Shimano OT-SP41 cable housing

Can't you by online? I bought from Spain, it's 38h drive from here:)

Spacer installation is completely normal. Orbea's own spacers are needed as those do interlock the knock block system to stem. Orbea spacers are fine and in my opinion even looks good.

Congrats. I don't know about Mezzer, but downtube will hit to Fox 38 on size M. My advise is to keep stock headset. It is fine quality from Enduro Bearings. The knockblocs will eventually brake, then you have no steering stop anymore. Those are designed to fail, so everything else keeps intact...