Recent content by kgoran79

As I said, I have a 34T chainring. The draining the air won't work for me as I ride a coil shock... ;) My problem is not how many links the chain must have, but setup key position and once set in SAG once not with the same chainstay length

I am about to install the transmission, but the chain and setup key guide works strangely. The Reign is not listed in the guide and has a chainstay of 454mm, and this setting is suggested (in my case 34T chainring): If I take for example the specialized stumpjumper evo which has a chainstay of...

Is the SRAM chainring also threaded like the praxis one?

I have the same problem, the freehub has been cleaned and greased several times, but it only worked for a short time.

I have also installed the update. What I noticed is that when I switch off the bike and want to switch it on again within 5 seconds, only the display flashes and goes out. The second attempt has always worked so far. I don't have a Garmin but a Sigma Rox 11.1, but since the update the cadence is...

thanks for the information. if the problem persists i will go to my LBS

I checked it, all wires are fully plugged in. The second from the left is a dummy plug? I had the battery out for the night, will check this afternoon to see if the problem is still there.

Today I had the first problems with the motor. After about 20km the motor suddenly stopped, switched on again, after 10 meters it stopped again. Battery out, waited a bit, back in. After a km again the same. I then made my way home, but on the last 5km the motor wouldn't turn on at all. At home...

What size mounting hardware do I need for the rear shock?

To modify the wheel circumference, for example. Then I have to downgrade to 4.8.0 to do that?

Hi @vadII , can yout tell me when the firmware version 4.9.0 will be supported?