Recent content by kamloopsmtbguy

Hi Greg! I just replaced the sprag clutches on my Brose Mag S from a Turbo Levo. I know that technically I should be using new stretch bolts, but I don’t have any, and I I’ve heard that reusing the original ones with some blue loctite should be okay once. My question is, what torque should I...

Hi Greg! I am currently rebuilding a Brose Mag S motor due to an exploded sprag clutch. My question is, how far do I press the right-hand crankshaft bearing (PLB20122) onto the torque sensor shaft? I measured before removing the bearing, and it was about 18mm, but I’ve also seen 17mm quoted as...

I’m more curious about when pressing the bearings back onto inner shaft, and also when pressing the sprag clutch (not the clutch itself) race and main pulley bearing back onto the aluminum main pulley.

Hi all, should I use any grease on the races of the bearings when rebuilding a brose mag s motor?