Recent content by Jeffrey

I own almost the same bike in 140... reaching soon 10'000 km :eek: These bearings are still original but I re-greased them at around 3000km... As there is no space between the two bearings, have you tried to push/hammer down both bearings at the same time? A cold-spray may help to win few...

The calorie count of a bosh system is very accurate because there is a power meter to measure the rider force input in the motor (magnetic torque sensor). On the kiox you can see your wattage input in live. Then by integrating the wattage over time the kiox get the total energy you put on the...

Switzerland - Valais / Wallis

Cube just put online the 2022 models on their website :D ...but... ... the motor/battery remain secret till 31.08 :(

Cube just put online the 2022 models on their website! 14% lighter than 2021 models! Nice new magnet system attached on the brake disc (centerlock or 6bolts): Seems that Bosch want to keep the new 2022 motor/battery secret till end of August:

Hi, I'm also from Valais, living near to Sierre ;)

Water flowing down to the turbine... ebikes climbing up on the other side of the wall :geek:

Was the Kiox rubber cap well closed when you washed it? No moisture when looking inside?

Of course :devilish: Joke apart the zee pads are again widely available at normal price in Switzerland since last week. I always buy at least 10 pieces at the same time to have wholesale price. As my standard ride in the alps is at least 1500D+/- and often muddy they wear out pretty quickly...

Amateurs! Somewhere in Wallis we have this beauty :cautious: I let you guess how bikers can go through... on the right side there is a 50m cliff, and on the left side the slope is >45°!

Some food for my Cube 140 SL :ROFLMAO:

On metal brake pads you don't need fins as they need to be warm to have the full braking power! Fins on metal pads is only marketing... Just go to the D02S: they are waay cheaper and actually easy to find at online stores.

Switzerland - Wallis / The snow finally started to melt in the altitude!

Another muddy ride ?

Looks nice! What's the thickness of the carbon sheets? How did you applied them? Just epoxy resin or also heating/drying?