Recent content by EbikeDoctor

The US and any S-Pedelec setting (EU or NZ) also shows the Warning, and starts in OFF mode, its not only Bosch thing, Avonix motors do the same with NZ settings!

Please check my signature under my post!

messaged everyone

I just made a quick video, how my m2s sounds, but in trail with the Amflow frame its amplified a lot. m2s rattle I'm not a fanboy of anything, especially companys, these are my subjective opinions, i don't care what others experience, right now this is what i experience.

Mine still rattles, and got so loud when you go down stairs,or uneven trails, the bosch gen4 cx rattle is nothing compared to this. Also when the motor is hot, the slow speed pedalling noise with low assistance get very crispy. Did not had the time visit the dealer yet, but heard the same...

yes, it does go up to 45km in NZ, old systems apparently not!

I tested new update,works fine.

I got one on my 2026 Fox 36 The Best upgrade i bought in the past 5 years. I'm pretty heavy, 90kg. My main problem with the oem Fox 36 was the middle stroke support, had to use high pressure to have it, which killed the inital sensitivity. With Rampair, little bit higher ramp up chamber...

Your are living in a country where doing tuning is literally a crime! https://www.pinkbike.com/news/french-government-introduces-30k-fine-for-emtb-tuning.html

PM sent to everyone

I messaged everyone.

This topic is became only Ebike support, for people having problems with their systems. Please stop posting tuning request here, if you have any questions, please send us a private message here!

Some people who used other peoples services, and were unlucky, got their brand identity changed or erased , might not get the 120nm update. Can PM me for help!

Check your PM!

Sure, everyone with any type of engine can update their bikes with May 4th update.