Recent content by Dario

XX cranks are around 350g, so I reduced the weight by almost 100g

174cm Size M

Today I went for the first ride with the Amflow PX Carbon and I noticed that on very steep hills in the stronger modes, my front wheel often lifts, tomorrow I will extend the chainstay, I hope that will help a little, but I am interested in which parameters in adjusting the assistance should I...

After changing to DHR/DHF tires, installing tubeless, and cranks (Sram XX), the weight dropped almost 1.2kg :)

Amflow PX Carbon out of box M Size Without pedals Without light

In the end I put a thin washer under the C-Clip to reduce the axial play and I also replaced this bearing because it didn't spin as smoothly as the others, I lubricated everything well and for now, after 200 km, everything works as it did when it was new :)

I didn't notice any wear or debris, the gunk inside the black cog is hardened grease, I don't see any scraping marks on the bearing und axial play ist about 1mm. The only thing is that my gear seems to be brass, not steel like yours, and it looks more worn than yours.

I opened my motor today, everything went quite easily, but I don't see any scraping marks like you have.

Thanks again, I'll take the my motor apart these days to see if there are any scratches like in your picture, I have some technical knowledge, so I'll try to solve it somehow :)

S13 thanks for the answer and it seemed to me from the sound that the problem is not in the bearings, the warranty has expired, unfortunately I don't have a donor motor, is there any possibility of repair?

exactly this sound (video from 2:00min)

Hello everyone, lately my e8000 has become louder and when after a few minutes of driving it warms up a bit under heavy load in trail and boost mode, a rather loud interrupted sound is heard (kweek-kweek). Otherwise, when I turn off the motor and pedal under full load, absolutely nothing is...

I think there was a misunderstanding, I want to buy one battery :)

Yes

OK, Thanks.