Recent content by czech99

do you mind sharing a picture of the gap between the cascade link and the upper pivot bearing? when i test fitted mine, there seemed to be quite a bit of gap compared to the stock linkage.

I used a punch and finally got it out. I ordered some new bearings anyways. but I had to hit it pretty hard before it started to finally budge

brass drift i assume?

Thought about that. Might give it another shot.

Yup see the photo above. I was using a mallet and a socket extension from the other side to tap the bearing puller. Even with slide hammer it didn’t come out.

Thanks. You have h or m series frame ? I have carbon and afraid of cracking. Not sure why mines stuck. I tried both left and ride side bearing using the blind hole remover

I unfortunately couldn’t get the bearing out so I had to take a pause on my install

Correct, but if you get the pre-load kit it requires the removal of 1 of the bearings to put that spacer/shaft in

was it hard removing the bearing in the upper pivot?

Curious if anyone with the pre load kit was able to install it yet.

M10 owner here. Definitely noticed rear end flex laterally

bumping this. anyone with a rise 2022 install this? is it basically plug in play? unplug the junction box and reuse those cables for the e7000?

I really enjoy my Roval Control Carbon 6B wheels that I put on my M10.

Just an FYI even** if the orbea had UDH it still wouldnt work because the entire system needs to work together. you cant just run a rear derailleur and casette like the old axs. You would need the new crankset w/ chainring that is unique to transmission. And with shimano steps you're not getting...