Recent content by Cisco

Product Description - Not available yet. They do that with their new bikes too...

My previous E8000 ebike had 3 motors. All had that play. None of the motors lasted more than 1400 miles. My current EP8 bike is still on the original motor and is coming up for 3100 miles. There is no play in this motors crankshaft. Can you tell I'm not superstitious..:)

Yeah, They're fine just spent lots with them but the whole eu/brexit thing is a pain. Also there is a minimum spend with them from the uk.

Hi Matt, My HS press was no use for this job. The largest press was too small for the bottom cup and, as the cables were still in when I did the bottom, the normal press could not be located in the top. I used a block of wood at the bottom and a bar with a threaded hole (actually the handle...

You don't need to remove the cables to replace the bottom bearing but you will have to remove the HS cup from the frame as the bearings are not available separately. I had to resort to a drift to remove the bottom cup. The replacement Acros bottom cup includes a new crown race; If you have had...

Lots of foam/soft cloth around the LHS chain/seat pivot. Bike solidly supported horizontally at the pivot. Drift the loosened axle out with increasing force till it moves while turning the Maxle if possible. good luck with it.

Check your pms :)

Your sram casette wont be helping however even if you know what your doing I think you will find this video useful for Shimano 12sp installation.

The TTX seems to be a good match for the Zeb ultimate. When it bottoms out it is usually cos I've fucked up and cased something hard, which has happened a few times when i run out of speed/talent pedalling a 25kg bike into a gap :(. Think u will find it suits the coil.:D

Hi there, the 21 VRX is still impressing at 300 miles and I can now confirm that the bike crashes well ? ? . WRT the rear spring I'm 85Kg kitted up and a 525LB spring on the TTX coil shock gives me +/-20% sag. I think that spring rate should be good on any make of coil shock for that rider...

Yeah, Lots of new riders coming to emtbs. They are paying £4K+++ for a bike and expect it to work. Problem is the drive trains are all still designed on 1 manpower input and the motors are modified car wiper units. Motor manufacturers are not helping by taking a "blackbox" attitude with No...

I'll be on a white Vitus. Quite a few of us tmrw. Will look out for you. ATB Frank

The cup/conical washer is dictated by the caliper. For example if you were using a Guide caliper instead of Guide RE caliper then the cup/cone spacer would not be required.

Yeah, I just checked what I bought, the SB001 mount I bought was from dirthut and was a 180-203. That doesnt seem to be available now. but the mount I linked will certainly be fine for the OP who was looking for 220 mount.

A few of us are up at the OKs tmrw. 9am at the playing fields car park...