I think I already have it figured out.
Apparently I just need the rotor magnet. This one lines up with the sensor (see photo).
Already removed the lockring magnet.
Nice of them to include both, just that bit confusing 😅
When swapping my wheelset on my new Kona Remote X, I found out it seems to have two magnets on the rear rotor.
Is this normal? Seems like a hard job lining hem up correctly.
It's for a Shimano EP800 system.
I just checked again. On the Customize tab the e tube app displays the options 'Assist' 'Drive Unit' 'Switch' 'Cycle computer' 'Wireless settings' 'Time'.
When I open the 'Drive Unit' it displays 'Max assist speed' and 'Display Speed'.
I'm using E-Tube Project Cyclist Ver.5.4.6 on Android.
BTW...
My app shows 'assist' and 'drive unit' when I'm on the customize tab.
Are you sure this applies for the EP800 system? Not just for the EP801? Can you use only sources that are EP800 specific, to verify?
Could you guide me step by step through the eTube mobile app? I can't seem to find the chainringsize setting.
I'm EU based by the way. Don't know if that might make a difference.
Could you link that 65 miles in four days post to me? I'm quite sure it's not mine. Wish it was!
It's the older one, the EP800.
How did you know about the 65 miles in four days?
I won't be changing wheelsize. Maybe a slightly wider tire, but definitely not a different wheelsize.