Recent content by boarder87

oh no, sorry for that =( It's a shame there isn't much information about this. Either it only affects a few people, or they've gotten used to the noise. Unfortunately, there are hardly any posts from people who have actually taken the motor apart. It doesn't seem to be anything complicated, at...

Can you tell me how it turned out? I can't say whether it's getting worse for me or if I'm just becoming more sensitive to it, but the noise is really getting on my nerves, especially when I'm riding with other non-E bikers.

I sucessfully upgraded to Eagle 90 Transmission. Replaced the trigger, direct mount eagle 90 derailleur, XS-1270 cassette and a new SRAM 36t T-Type chainring, the spider was 104BCD and it seems that i already was a 55mm offset. Chainring war possible to remove and assamble a new one....but it's...

Thanks for all the informations. I thought the chainring also need to be changed because transmission inner width is slightly smaller? Good point...I think transmission rely on 55mm Chainline, but idk what spider is mounted...I already found informations that the reign have a 55mm CL spider but...

A few days ago I totally crashed my GX derailleur, hanger, chain... Also the smallest cogs of the cassette are worn out. I thought about upgrading to eagle 70 or 90 T-Type. AXS is too expensive for me, also I prefer a mechanical shifting. All parts on the rear are clear to me but I don't know...

Hey, luckily I was able to replace the dropper cable today. Above the motor it's just space for one Bowden tube. I've tried to tape the new one to the old one but both don't fit above the motor inside the frame. But with an old thin cable I was able to pull and push a new Bowden tube in the...

ah sorry. Dropper post was the term that I couldn't remember, at least everyone understood that it was about the tube, not just the steel cable. I'm wondering, that i can push and pull the cable a litte bit forward and back while pushing and pulling the dropper post, but at a point it's getting...

Hi all, Unfortunately I need to replace the internal Bowden tube of the seatpost. I can't pull the seatpost out of the frame even that I have removed the battery and try to push the Bowden tube from the bottom. The tube is going somewhere over the motor and is stucked. Could the motor somehow...

Good to know, would be great if there is something to solve this issue, even I don't know exactly where the noise is coming from and what the motor repair center will do in detail. Please keep us updated about costs and success.

I've answered already on another thread. Have the same problem of this noise on higher cadence and first two assist modes. That really annoys me.

Had also a replacement motor after 2 months of s new bike. The new motor was better than the first, but not good. Since a few weeks, the noises are getting louder and more after. Can't bike with bio bikers anymore, because on Eco it even disturb others...:(

Ah, sorry my fault. I forgot that there is another unit than meters 😁

5000-6000m elevation gain? Are You serious? With 2 times of fully charging I guess?

Had the same issue after a few months and disassembled, cleaned, regreased the headset several times. Mostly after one or two rides the creaking came back. Anyhow the last time I used a different grease and now it's silent during the whole summer.

Thanks...finally someone who explains the differences between the rims. To be honest, I would have expected bigger differences, but it's amazing what a few tenths make in the end.